Getting StartedWhere to BuyHelp TopicsE-mail Newsletter
For Commercial

Care and Cleaning Special Considerations
Image of Whirlpool System
Flushing a Whirlpool System

Flush your whirlpool system twice a month or more, depending upon usage.

  1. Adjust the jets fully clockwise so there is no air induction.
  2. Fill the bath with warm water to a level 2" above the highest jets, or leave water in the bath after using.
  3. Add 2 teaspoons of a low-foaming, powder automatic dishwasher detergent and 20 ounces of household bleach (5% to 6% sodium hypochlorite) to the water.
  4. Run the whirlpool for 5 to 10 minutes. Then shut off the whirlpool and drain the water.
  5. If desired, rinse bath surfaces with water.
  6. Clean KOHLER® cast iron and acrylic bath surfaces as needed with recommended cleaners.

Success with cleaners and procedures is dependent upon such factors as the hardness and temperature of the water, using exact measurements of ingredients, changes in cleaning formulas and the condition of the product being cleaned. Since there are variations within these factors, Kohler cannot guarantee the effectiveness of the formulas mentioned.

Legal Privacy Cookie Policy Kohler Co. Copyright ©2019 Kohler Co.
My Kohler
Save, print and share your product selections online with My Kohler Folder.

RegisterRegister   |   Log inLog in

Trade Professional